Pipe layout: spiral or serpentine
The pipe can be laid in two main patterns. The choice changes how evenly the floor warms and how many sharp bends the pipe has to take.
Serpentine: back and forth
The pipe runs in parallel lines from one side of the room to the other and turns at the end of each line. It is simple to lay and the loop is easy to follow. The drawback is that the hot supply end and the cooler return end are on opposite sides, so the floor is warmer on one side of the room and cooler on the other.
Spiral: supply and return side by side
In a counterflow (double) spiral the pipe goes in towards the middle of the room and comes back out between the same turns. Hot and cooler pipe then lie next to each other, so the surface temperature evens out across the whole room. There are no 180° turns along the walls, only gentle bends.
| Serpentine | Spiral (counterflow) | |
|---|---|---|
| Floor temperature | Warmer at the supply side | Even across the room |
| Bends | Many tight 180° turns | Gentle curves |
| Laying | Simple | Needs more planning |
| Good for | Narrow rooms, edge zones by windows | Living rooms and larger rooms |
Mind the bend radius
A pipe that is bent too tightly can kink and cut off the flow. Keep every bend no tighter than the pipe maker allows, usually about 5 times the pipe diameter, so about 8 cm for 16 mm pipe. At 10 cm spacing a 180° turn is already close to that limit.
How to choose
- For most living spaces the spiral gives the more even floor.
- In narrow rooms and corridors a serpentine is often the natural fit.
- Along outside walls and large windows the pipes can be laid closer; see the guide on pipe spacing.
- Whichever pattern you choose, keep to the same spacing and keep the loop within its length limit.